S3StickWHL-BLK-TRL
S3 Wheel Rim Sticker Kits (various colours)
S3 Wheel Rim Stickers, Trial, MX, and Enduro bikes. These both give the bike a really destinctive sharp look, and protect the rims at the same time. The stickers are a really thick, durable, dimpled finish, that when fitted correctly, last for years, and enhance the bikes looks really well.
The Trial type fits both 18 and 19" rear rims, and 21" fronts or smaller.
Colour options:
Black, Red, Blue, White, Fluoro Green, Fluoro Orange, Fluoro Yellow and Camo.
Secure Payment Methods
-
EFT - Bank Deposit
-
PayPal Express
-
Web Payments
-
Web Payments
-
zipMoney
-
American Express
-
MasterCard
-
Visa
Kit fits a complet bike - front and back wheels / both sides - 3 stickers per rim side (6 per wheel, 12 in kit)
21" fronts and 18" rears for trials bike rims.
CHECK OUT THE VIDEO TAB ABOVE FOR FITTING INSTRUCTIONS.
Here is a couple of installation videos from S3, but I have to say after doing lots of these I do prefer to fit from the outside of the rim, and work my way in towards the spokes (the exact opposite of what's on the video).
The real trick is super clean rims. Get some Wax and Grease remover, or similar, onto to every bit of the surface, and make sure they are super clean.
I leave a good 1mm, or so, gap around the edge to leave room for tyre irons etc. Then use a heat gun or Hair dryer to soften the stickers (makes them more pliable) as you put them on.
Overlap the stickers in the direction the tyre rotates, so if you clip something with your rims it wont peel the join away.
| SKU | S3StickWHL |
| Brand | S3 |
| Shipping Weight | 0.3000kg |
Be The First To Review This Product!
Help other The Hell Team Trials Store users shop smarter by writing reviews for products you have purchased.
Here is a couple of installation videos from S3, but I have to say after doing lots of these I do prefer to fit from the outside of the rim, and work my way in towards the spokes (the exact opposite of what's on the video).
The real trick is super clean rims. Get some Wax and Grease remover, or similar, onto to every bit of the surface, and make sure they are super clean.
I leave a good 1mm, or so, gap around the edge to leave room for tyre irons etc. Then use a heat gun or Hair dryer to soften the stickers (makes them more pliable) as you put them on.
Overlap the stickers in the direction the tyre rotates, so if you clip something with your rims it wont peel the join away.
